Oxidation, and the peroxide that came in with the surfactant

The single most consequential fact about deamidation is that the isoaspartate product has the same molecular weight as the parent peptide, because the rearrangement moves an atom rather than adding or removing one. A laboratory confirming identity by molecular ion mass alone will report a substantially deamidated preparation as the intended compound. Separation is possible — the isomers usually resolve on a sufficiently shallow reversed-phase gradient, and specialist methods resolve them reliably — but only if the method was designed to look. A twelve-minute generic gradient does not look.

Deamidation, and the isomer with the same mass

Deamidation of asparagine proceeds through nucleophilic attack by the backbone nitrogen of the following residue on the asparagine side-chain carbonyl, forming a five-membered succinimide intermediate which then hydrolyses to a mixture of aspartate and isoaspartate, conventionally in a ratio favouring the isomer roughly three to one. Glutamine deamidates by an analogous route, far more slowly, through a six-membered intermediate.

Three factors govern the rate. Sequence is dominant: the residue immediately following the asparagine determines how readily the intermediate forms, and asparagine-glycine is the fastest motif known, with serine, histidine and alanine following. Solution pH matters, with the rate minimal in the mildly acidic region and rising steeply above neutrality as the backbone nitrogen becomes more nucleophilic. Temperature and water activity set the overall pace, which is why the solid state helps so much.

The analytical problem is that isoaspartate has the same elemental composition and therefore the same molecular mass as the parent. Identity confirmation by molecular ion alone cannot distinguish them, and a preparation that is substantially deamidated will present as the intended compound. The isomers usually separate on a sufficiently shallow reversed-phase gradient, and specific methods exist, but only a method designed for the question will find the answer.¹

The documentation stops at the moment before the diluent goes in, and every practical question a buyer has begins at the moment after. In-use stability is where the losses happen and where there is least published data, for any supplier in this market.

Oxidation, and where the oxidant came from

Methionine oxidises to the sulfoxide and, under harsher conditions, the sulfone. Tryptophan oxidises through a series of products including kynurenine derivatives. Histidine and tyrosine are susceptible under metal-catalysed conditions, and free cysteine oxidises readily to disulphide. Each of these products differs from the parent by a defined mass increment, which makes oxidation the pathway most reliably detected by mass spectrometry: the sulfoxide is sixteen mass units heavier and unmistakable.

The interesting question is usually where the oxidant came from, and the answers are mundane. Trace transition metals leached from glass, stainless steel or a stopper catalyse oxidation of several residues. Peroxides accumulate in polysorbate surfactants during storage and are a well-documented source of methionine oxidation in formulated products. Dissolved oxygen in the diluent contributes. Light drives it, particularly for tryptophan, and light exposure during handling is entirely undocumented in this trade.

Practical consequences follow that are not obvious. A formulation containing a surfactant that has itself been stored warm for a year may oxidise a peptide that would have been perfectly stable in a plain aqueous vehicle. Headspace composition matters: vials backfilled with nitrogen behave differently from vials sealed under air, and the difference is a manufacturing choice recorded nowhere on the label.²

Aggregation, and the method that dissolves the evidence

Aggregation covers a range of species from soluble dimers to visible particles, formed by covalent routes such as disulphide scrambling or by non-covalent association of partially unfolded monomers. For peptides the process is often nucleated at an interface — the air-water interface of a shaken vial, the silicone oil layer on a siliconised stopper, the ice-water interface formed during freezing — which is why mechanical handling and freeze-thaw cycling matter as much as temperature.

The analytical difficulty is severe and specific to the trade’s chosen method. Reversed-phase chromatography runs in an acidic, partly organic mobile phase which dissociates most non-covalent aggregates before or during separation. The aggregate is loaded and the monomer is detected. Size-exclusion chromatography under non-denaturing conditions separates by hydrodynamic volume and reports high molecular weight species directly; analytical ultracentrifugation and light scattering methods characterise them further. None of these is offered as a routine service to this market.

The consequence for a reader is that the aggregate content of a research vial is, at present, an unmeasured quantity. It is not necessarily a large one — well-made lyophilised peptides are frequently very low in aggregate — but no certificate in circulation addresses it, and the purity figure that is printed instead is generated by the one method guaranteed not to see it.³

What makes a method stability-indicating

A stability study is only as good as the analytical method behind it, and the requirement has a name: the method must be stability-indicating, meaning it must resolve the parent compound from its degradation products and quantify the change. Establishing that is done by forced degradation — deliberately stressing the material with acid, base, oxidant, heat and light — and demonstrating that the resulting products are separated from the parent and from each other with adequate peak purity.

Almost nothing sold as a purity determination in this market has been validated that way. A generic peptide gradient run for twelve minutes may perfectly well resolve the parent from its two largest process impurities and entirely fail to resolve it from its isoaspartate isomer or a closely related oxidation product. The number it returns is a purity figure, not a stability measurement, and using a series of such figures to argue that a product has not degraded is a category error.

The compendial guidance on analytical validation is explicit about specificity, and about demonstrating it against the degradation products the molecule can actually form. The gap between that expectation and practice in this trade is not a matter of dishonesty. It is that the method being sold was designed for a different purpose and is being asked a question it was not built to answer.⁴

Why accelerated data extrapolates badly for peptides

The temptation with any stability programme is to run the accelerated condition, fit an Arrhenius relationship to the rate constants, and extrapolate to the intended storage temperature. For a single reaction with a temperature-independent mechanism that is sound. For peptides it frequently is not, and the reason is that different pathways have different activation energies.

Suppose a peptide degrades at five degrees principally by deamidation and at forty degrees principally by hydrolysis, with the second having a higher activation energy. Measuring total degradation at forty degrees measures mostly hydrolysis; extrapolating that rate down to five degrees predicts almost nothing about the deamidation that will actually dominate. Aggregation is worse still, because it is frequently nucleated by interfaces and mechanical stress rather than by thermal energy alone, and does not obey a simple temperature relationship at all.

The practical rule the Journal applies when reading a stability claim is to ask what condition the data was generated at and whether the degradation products were identified as well as quantified. Accelerated data that shows which products form is genuinely useful as a warning of what to watch for. Accelerated data reduced to a single percentage and extrapolated to a shelf life is a projection dressed as a measurement, and for this class of molecule it is a poor projection.

Almost every temperature excursion this desk has logged has occurred in the final forty-eight hours of a journey. The long international leg is engineered and monitored; the last mile is improvised, and the pack was specified for the route somebody planned.

Light, and the exposure nobody records

Photostability has its own guideline, its own defined light source options and its own exposure requirement expressed in lux hours of visible light and watt hours per square metre of near ultraviolet. Products are tested in the immediate container, and where they fail, in the marketing pack, and where they fail again the label carries a protection instruction. The chemistry is real: tryptophan and tyrosine absorb in the near ultraviolet and photo-oxidise, and photolytic disulphide cleavage is well documented.

Nothing about light exposure is recorded anywhere in the research-peptide supply chain. Vials are frequently supplied in clear glass. Photographs for listings are taken under studio lighting. Parcels are opened on kitchen counters. A reconstituted vial may sit on a shelf under a window for weeks. The cumulative exposure is unknown and unknowable, and it is plausibly a larger contributor to degradation than the transit excursions that attract all the attention.

The Journal makes one narrow observation rather than a recommendation, because recommendations are not this publication’s business. Amber glass, or a secondary carton, costs a fraction of a cent per unit and removes an uncontrolled variable entirely. Several of the twenty companies we track ship in amber vials as standard, and the remainder will supply amber on request at no extra charge, which is the answer a buyer who cares about photostability should ask for.⁵

The customs leg remains the part of this story we cannot report properly, and it deserves saying every time the subject comes up: there is a segment of every cross-border journey during which nobody measures and nobody has authority to intervene. Any claim of end-to-end control across that segment is a claim about something unobserved.